If start of injection (specified) is earlier than 3 BTDC, engine too cold. Start of injection (actual): 2 ATDC - 3 BTDC Start of injection (specified): 2 ATDC - 3 BTDC 550mg/H over the complete RPM and load range. If a DTC is present, air mass actual will have a constant value of approx. Reading should be within that time period.)

(Note: EGR is turned off after approximately 2 minutes of idle. If air mass actual is above 370 mg/H, engine is cold, insufficient EGR, or bad MAF sensor If air mass actual is below 230 mg/H, excessive EGR or an air leak. If air mass specified is above 370, engine too cold. Operating condition right digit: AC compressor switched onĪir mass drawn in (specified): 230 - 370 mg/HĪir mass drawn in (actual): 230 - 370 mg/HĮGR vacuum solenoid duty cycle: 40 - 75 % Operating condition middle digit: Closed throttle position switch is closed (foot not on pedal) Operating condition left digit: 1 = idle increased because AC is on Throttle should go 0 - 100 depending on pressure applied to 'go' pedal If above 2.000 volts - injection is too lean, or engine is cold If below 1.450 volts - injection too rich If above 9.0 - injection is running too lean, or the engine is cold If below 2.2 - injection is running too rich Modulating piston displacement sensor voltage: 1.450 - 2.000 VĮngine coolant temperature sensor: 80 - 110 C These are valid ranges only when the EGR is switched on, engine at idle and at least 80C (176F) coolant temp. Intake Manifold Temperature: 182 - 50 = 10 - 110 degrees Cįuel Temperature: 91 - 201 = 20 - 80 degrees C

Injection quantity: 11 - 45 = 2.2 - 9.0 mg/strokeĮngine coolant temperature: 80 - 35 = 80 - 110 degrees C Start of injection: range 12 - 75 = 2 degrees ATDC - 3 degress BTDC Actual labels/values displayed may vary.Įngine idle speed: range 42 - 45 = 870-950 Vous avez qu'à ajouter le numéro du groupe que vous voulez voir!!īased on the Bentley CD but includes other groups not documented there. Pour débuter voici la liste des mesures qu'on peut avoir accès avec Vag-com/Vcds avec le numéro du canal. Je ne suis pas un expert, au contraire, j'ai fait des recherches et j'ai trouver des procédures, donc je les mets à profit de tout le monde!! J'ai fait des recherches et j'ai pas trouver de sujet sur des procédures vag-com/Vcds de base.

Vag com activation code generator